NEC Express5800 User Manual page 365

Optional RAID Controller (N8103-129/130)
Your server can include the optional RAID Controller (N8103-129/130). The optional RAID
Controller can control the internal hard disk drives as the RAID System. To use the hard disk drives
in a RAID System, reconnect the hard disk drive interface cable on the mother board.
At the factory, the interface cable is connected to the serial ATA connector on the mother board.
Refer to the manual coming with optional RAID Controller (N8103-129/130) for details.
IMPORTANT:
static electricity. Make sure to touch the metal frame of the Server to
discharge static electricity from your body before handling the RAID
Controller. Do not touch the RAID Controller terminals or on-board
parts by a bare hand or place the RAID Controller directly on the desk.
For static notes, see the section "Anti-static Measures" described earlier.
NOTE:
utility, select [Advanced] → [PCI Configuration], and confirm that
[Enabled] is set for the parameter [PCI Slot xx ROM] (xx: PCI slot
number).
The RAID Controller board is extremely sensitive to
Before installing an optional RAID Controller, run the SETUP
Upgrading Your Server 9-27