NEC Express5800 User Manual page 400

9-62 Upgrading Your Server
7.
Remove the rails and screws from the factory-installed optical disk drive. Then, install
them to the optional DVD SuperMULTI drive.
8.
Slowly and carefully insert the optional DVD SuperMULTI drive back in its place.
NOTE:
the internal cables are not caught with the drive.
9.
Secure the optional DVD SuperMULTI drive with the two screws you have removed in
Step 5.
10.
Check whether the installed optional DVD SuperMULTI drive is projected too much from
the front of the server.
11.
Connect the interface and power cables to the optional DVD SuperMULTI drive from one
side of the server.
See Chapter 10 for details.
IMPORTANT:
cause a malfunction to occur. Provide the connection securely watching
the optional DVD SuperMULTI drive and cable connectors.
NOTE:
12.
Install the components you have removed in earlier step.
Install the optional DVD SuperMULTI drive carefully so that
Bent connector pin or incomplete connection may
Make sure that the cable is not caught.