Flash Fdd - NEC Express5800 User Manual

Flash FDD

A Flash FDD is a device that has capacity compatibility with a floppy disk drive.
One Flash FDD can be connected to a USB connector of this server. If a floppy disk drive is
connected to this server, be sure to disconnect it.
IMPORTANT:
The status of the write protection switch of the Flash FDD from

before it is connected to this server is applied. Therefore, flipping
this switch after connecting the Flash FDD has no effect. If it is
necessary to flip this switch during use, temporarily disconnect the
Flash FDD from the server, and then flip the switch.
Be careful not to accidently slide the write protection switch while

connecting the Flash FDD to or disconnecting it from the server.
Notes
The Flash FDD is only intended as a temporary means of performing processing such as reading
device drivers during installation, so do not use the FDD to back up data.
Compensation for recorded data
NEC will not pay compensation for data recorded on the Flash FDD if the data is lost.
Be extremely careful not to lose the Flash FDD or have it stolen.
If the Flash FDD is lost, stolen, misappropriated, or fraudulently obtained,
there is a risk of leaking confidential information to a third party. NEC
assumes no responsibility for damages caused by leaking confidential
information in this way.
CAUTION
General Description 2-27