NEC Express5800 User Manual page 510

F-6 Installing Windows Server 2003 x64 Editions
8.
Windows Server 2003 x64 Edition OEM-Disk for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.
IMPORTANT: If you have created "OEM-Disk" into the Flash FDD,
disconnect it after the NEC EXPRESSBUILDER had been shut
downed.
NOTE:
write-protected.
Cancel write-protected state.
If you have already cancelled write-protected state, connect the floppy
disk drive again.
Create from [Autorun Menu]
This menu requires Microsoft Windows XP, Vista or Windows Server 2003(or later).
You can create Windows Server 2003 x64 Edition OEM-Disk for EXPRESSBUILDER from
[Autorun Menu], if you have the computer on which the above operating systems operate.
Follow the steps below.
1.
Prepare one Flash FDD, or one USB floppy disk drive and 3.5-inch floppy disk.
2.
Start the Operating System.
3.
Insert the NEC EXPRESSBUILDER DVD into the optical disk drive of the server.
The Menu will appear.
4.
Connect the Flash FDD or the USB floppy disk drive. (If you use the floppy disk drive,
insert a floppy disk into it.)
5.
Click [Create drive disk] and select [OEM-Disk for Windows Server 2003 x64 Edition].
NOTE:
Right-click.
6.
Windows Server 2003 x64 Edition OEM-Disk for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.
If the following message is displayed, the floppy disk is
You can do the same operation with the menu appeared by the