NEC Express5800 User Manual page 406

9-68 Upgrading Your Server
4.
Make the component side of the board face the bottom of the server, slowly insert the
board aligning the board connector with the slot on mother board.
NOTE:
the groove of the guide rail on the server and then connect the board to
the slot.
5.
Push the board fully so that the board connector is certainly connected to the slot.
IMPORTANT:
board once and then reinstall it. Excess force added to the board may
cause the board to be broken.
6.
Fix the board with a screw removed in Step 3.
7.
Reinstall the removed components.
8.
Turn on the power of the server. Then make sure that any error message does not appear in
POST.
If an error message appears, write down the message and review the error message list in
Chapter 8.
Removal
Remove the board in the reverse procedure of the installation. Then install the additional slot cover.
For a long-sized board, align the right end of the board with
If the board cannot be installed easily, remove the
Guide rail