Table of Contents
Advertisement
4.
Firmly hold the drive carrier, and pull out the hard disk drive. Do not hold the handle.
5.
If using the server with the hard disk drive removed, install the dummy tray in the vacant
slot to ensure the cooling efficiency.
6.
Power on the server, and run the SETUP utility.
Select the [Boot] menu (described on page 4-33) to set the boot priority. When you install
an additional hard disk drive, the boot priority stored in BIOS is cleared.
7.
Install the front bezel you removed in step 2.
Upgrading Your Server 9-17
Advertisement
Table of Contents
Troubleshooting
