NEC Express5800/R320a-E4 User Manual page 107

Stop the operation of a PCI module using the ft server utility.
3.
Select [Start] - [All Programs] - [NEC ESMPRO Agent] - [ft server utility] to start the
ft server utility.
Then, from the ft server utility, select [PCI Module] and then the primary PCI module
(*) from the [FTSever] tree on the left pane, and click [Down] of [Bring Up/Bring
Down].
* As for the primary PCI module (*), if the PCI module 10 is primary select [PCI
Module(ID:10)]. If the PCI module 11 is primary, select [PCI Module (ID:11)].
When you stop the operation of the primary PCI module, a failover occurs and the
secondary PCI module becomes the primary module.
The following events or changes occur when stopping the primary PCI module and the
module fails over:
The screen temporarily blacks out and then displayed again.
Indications of PCI modules' status LEDs change as follows:
[Indications of status LEDs]
1 PRIMARY LED
2 DISK ACCESS LED
3 System FT LED
* The primary and secondary modules after failover
LED
LED
Windows Setup and Operation 3-37
Secondary*
-
- Amber or Green blinking
(Green when accessing to
System
-
Primary*
Green
HDD)