Confirm Start And Stop Of Cpu Modules - NEC Express5800/R320a-E4 User Manual

3-40 Windows Setup and Operation

Confirm Start and Stop of CPU Modules

This section describes how to confirm the continuous system operation after stopping one of the
CPU modules.
Confirm that the CPU modules are duplicated.
1.
To check if the CPU modules are duplicated, see the status LEDs of the CPU modules.
2
[Indications of status LEDs when CPU modules are duplicated]
1 PRIMARY LED
2 DISK ACCESS LED
3 System FT LED
Use the ft server utility to stop the operation of a CPU module to remove.
2.
From [Start], select [All Programs], [NEC ESMPRO Agent] then [ft server utility] to start the
ft server utility. Then, from the ft server utility, select [CPU Module] then the CPU module to
stop (*) from the [FTSever] tree on the left pane, and click [Down] of [Bring Up/Bring
Down].
* As for the CPU module to stop, select [CPU Module(ID:0)] to stop CPU module 0, select
[CPU Module(ID:1)] to stop CPU module 1.
1
LED
LED
Secondary
(Operating)
Green
Green
System
Green
3
Primary
(Operating)
-
Green