NEC Express5800/R320a-E4 User Manual page 380

7-14 Troubleshooting
Screen freezes, keyboard and mouse don't work:
→ If the amount of memory is large, it takes time to copy the memory in dual mode
and the system stops working temporarily during the copying, but it is not system
trouble.
Message "New Hardware Found" appears:
→ Such a message may appear at the system startup or when a CPU/IO module is
replaced and incorporated into the system. This is due to the server's operating
specifications and does not pose any problem.
Fail to access (read or write) to the floppy disk:
Does the floppy disk drive contain a floppy disk?
→ Insert a floppy disk into the floppy disk drive until it clicks.
Is the floppy disk write-protected?
→ Place the write-protect switch on the floppy disk to the "Write-enabled" position.
Is the floppy disk formatted?
→ Use a formatted floppy disk or format the floppy disk in the floppy disk drive.
Refer to the manual that comes with the OS for formatting a floppy disk.
Fail to access (read or write) to the Flash FDD:
Is the Flash FDD write-protected?
→ Place the write-protect switch on the Flash FDD to the "Write-enabled" Position.
Is the Flash FDD formatted?
→ Use a formatted Flash FDD. Refer to the manual that comes with the OS for
formatting.
Is another Flash FDD or a floppy disk drive connected to this server besides this
Flash FDD?
→ One Flash FDD can only be connected to a USB connector of this server.
If another Flash FDD or a floppy disk drive connected to this server, use it after
removing these.
The Flash FDD doesn't operate normally after failover.
Reconnect Flash FDD once after removing.
→ When the server process failover with the Flash FDD connected, the Flash FDD is
not normally recognized. In that case, once remove the Flash FDD, and reconnect
to this server.