NEC Express5800/R320a-E4 User Manual page 189

Setting] of the [General] sheet.
The community names to receive SNMP packets from are listed in the [SNMP
Community] list box.
Click [OK] to terminate the operation.
3.
Monitoring by NEC ESMPRO Manager
If the version of NEC ESMPRO Manager is older than that of the target NEC ESMPRO Agent, its
operation is not guaranteed. Some items cannot be monitored. Use the same or newer version of
NEC ESMPRO Manager than that of NEC ESMPRO Agent for monitoring.
When Performing Duplex System Management
To perform duplex system management, install NEC ESMPRO Agent on a local disk on both the
operating and standby servers. The installation procedure for NEC ESMPRO Agent is same as a
normal installation, except that it should be installed on two servers.
Serial Port
For the models supporting serial ports, please note the following.
NEC ESMPRO Agent has multiple features that use serial ports.
When using these features, the ports may become insufficient.
The serial ports available for each feature are as follows.
UPS: COM1-10
APCU: COM1-2
ALIVE Maintenance*: COM1-9
*Alive Maintenance uses Remote Access Service.
The available serial ports when using Remote Access Service for Manager Report (TCP/IP
Out-of-Band) are as follows.
Manager Report: COM1-10
Among those above, only the following combination can share the serial ports.
• Alive Maintenance + Remote Access Service used by a user
When one of the features uses the line, the other feature cannot be used.
Manager Report (TCP /IP Out-of-Band), which uses Remote Access Service, may be unable to
notify failure information when sharing other serial port. Ensure not to share serial ports.
The monitoring event is not alerted
- The alert function is based on the event information registered in the event log of the system.
Thus, set the event log process on the event viewer to [Overwrite events as needed]. The
monitoring event is not alerted in the setting other than that.
Installing and Using Utilities 5-29