Table of Contents
Advertisement
1 BASIC OPERATION
•
PC Test Mode
(Refer to 24.2 PC Test Mode.)
The PC Test Mode is a mode to activate by the
TUNING command sent from a computer, and in this
mode, you can control transmission and reception by
the computer.
•
PC Tuning Mode
(Refer to 24.2.3 PC Tuning Mode.)
This mode allows you to adjust various transmission
and reception adjustment under the PC Test Mode.
•
Firmware Programming Mode
You can program a firmware update in this mode. You
are able to program the firmware using a special
software (FPRO.EXE) and a programming speed is
115200 bps, 57600 bps, or 38400 bps. The DSP
software is also written into a flash memory.
" Transition to each mode
Command
Power ON
User Mode
Command
PC Firmware Programming Mode
Power ON
+
PF1 key
PF1 key
Note: The Firmware Programming setting must be enabled by
FPU before entering into PC Firmware Programming Mode.
(Refer to 14 Firmware Programming Mode Setting.)
4
(Refer to 25 Program.)
PC Mode
PC Programming Mode
Command "E"
PC Test Mode
115200 bps Mode "P.G."
PF1 key
57600 bps Mode "P.G."
PF1 key
38400 bps Mode "P.G."
Function Reference (FUNC)
1.6
Display
Following are display functions of the front panel:
" LED
•
7-segment LED: 2 digits
•
TX LED: red
•
BUSY LED: green
•
POWER LED: green and red
•
PF1 to PF6 keys LED
1.6.1
7-segment LED
Alpha-numeric characters are displayed by switching On
and Off 7 bars.
All segments unlit
Figure 1-3 All 7-segment LEDs while lit and un-lit.
Figure 1-4 Available characters
Note:
# Although you can use "A" to "_", you cannot use the upper "C"
since it is used in the scanning display and the Programming
Mode display.
# In addition, you cannot use "K", "M", "V", "W", "X", and "Z".
All segments lit
Version: 1.01 USA
Advertisement
Table of Contents
