Multi-Table - Kenwood TKR-750-850 Function Reference

21 MULTI-TABLE

This function allows you to wait for a call a maximum of
15 QT/DQT by configuring 15 QT/DQT (Current) as well
as a single QT/DQT (Primary) to each channel. With this
function, you can receive a call from many transceivers
that have different QT/DQT code. You can activate/
deactivate the Multi-table function for each channel.
(Refer to 4.7 Encode Tone in Multiple.)
With the Multi-table function, you can configure the QT/
DQT code to the Main-table and the Sub-table. You can
switch the Main-table and the Sub-table interlocking with
the operation of the function key and the input/output
operation of the auxiliary port. (Refer to FPRG 13
Function List.)
Note: You cannot use the Main-table and the Sub-table at the
same time. TKR-750/850/751/851 waits for a call with the
QT/DQT code configured to each channel and the QT/DQT
code configured to the Main-table or the Sub-table.
! Configuration of KPG-91D
" Configuring the QT/DQT code of the Multi-table
(Refer to FPRG 6.11 "Multi-table" window.)
Version: 1.01 USA Function Reference (FUNC) 52