Tx Standby On Frequency - Kenwood TKR-750-850 Function Reference

13 TX STANDBY ON FREQUENCY

This function allows you to make TKR-750/850/751/851
standby at a transmission frequency configured to each
channel when it operates in a reception mode. You must
switch this function Off in case of transmission frequency
shifts.
When TKR-750/850/751/851 is installed within a building,
not on a position, such as the top of a building or
mountain, the user having a transceiver may approach
within a couple meters of it. In this case, the transceiver
may become busy even when it does not transmit due to
the cabinet radiation of TKR-750/850/751/851 while the
TX VCO standby on the programmed frequency. This
problem also may occur when making a operation test or
demonstration during the installation. This problem can
be avoided by shifting the TX frequency by 18.75 kHz
when it is operating in standby mode while the TX
Standby on Frequency is disabled. However, the rise time
of the transmissions delay approximately 15 to 20 ms
when this function is disabled, so that we recommend you
to normally switch this function On.
! Configuration of KPG-91D
" Configuring the TX Standby on Frequency (Refer
to FPRG 6.4.1 "Optional Features 1" tab.)
Version: 1.01 USA Function Reference (FUNC) 30