Table of Contents
Advertisement
4 CHANNEL INFORMATION
# When QT Encode and the QT Reverse Burst function are
enabled, TKR-750/850/751/851 transmits the QT Reverse Burst
code at end of transmission.
#
When the DQT Encode is selected, TKR-750/850/751/851
transmits the QT Turn-off Code at end of transmission.
! Configuration of KPG-91D
" Configuring the QT/DQT Encode (Refer to FPRG
6.2.4 QT/DQT Encode.)
4.5
Channel Name
You can assign 2 digit characters to each channel name.
The configured channel name appears on the Channel/
Status display.
(Refer to 1.6 Display.)
! Configuration of KPG-91D
" Configuring a Channel Name (Refer to FPRG
6.2.5 Channel Name.)
4.6
Wide/ Narrow
You can choice a transmission bandwidth. The value
depends on the area or your license.
Bandwidth.)
! Configuration of KPG-91D
" Configuring the frequency bandwidth (Refer to
FPRG 6.2.6 Wide/ Narrow.)
4.7
Encode Tone in Multiple
This function allows you to wait calls with maximum 16
different QT/DQT codes by setting additional 15 QT/DQT
(Current) as well as the QT/DQT code (Primary) set on a
each channel. You can set a Main code and a Sub code
in a Multi table.
(Refer to 21 Multi-table.)
TKR-750/850/751/851 encodes QT/DQT Encode code
matching QT/DQT Decode in primary and current QT/
DQT codes while it operates under Repeat Mode or
Duplex Mode.
Note: You cannot use Multi Table while the TKR-750/850/751/851
operates under Simplex Mode.
Mode.)
If TKR-750/850/751/851 receives a transmission request
from Local Mic PTT or external PTT except Simplex
Mode, it automatically selects the signalling code to
10
(Refer to 1.4
(Refer to 4.8 Operation
Function Reference (FUNC)
transmit. (The operation of repeat PTT switch is
excluded.)
The encode operation varies depending on the PTT type.
Version: 1.01 USA
Advertisement
Table of Contents
