Table of Contents
Advertisement
4 CHANNEL INFORMATION
A pair of transmission and reception frequencies is called
as channel for making a communication. You can
configure maximum 16 channels in order to transmit and
receive.
You can configure following functions by KPG-91D.
RX Frequency
TX Frequency
QT/DQT Decode
QT/DQT Encode
Channel Name
Wide/ Narrow
Encode Tone in Multiple
Operation Mode
Multi Table
Beat Shift
TX High Power
QT Reverse Burst
Scan Add
Compander
CW ID
Scrambler
! Configuration of KPG-91D
" Configuring a channel (Refer to FPRG 6.1
"Channel Information" window.)
4.1
Reception Frequency
This is a frequency used for reception.
You can specify your desired receiving frequency within
the range.
(Refer to 1.2 TX/RX Frequency.)
! Configuration of KPG-91D
" Configuring the Reception Frequency (Refer to
FPRG 6.2.1 Reception Frequency.)
Version: 1.01 USA
4.2
Transmission Frequency
This is a frequency used for transmitting.
You can specify your desired transmitting frequency
within the range.
! Configuration of KPG-91D
" Configuring the Transmission Frequency (Refer to
FPRG 6.2.2 Transmission Frequency.)
4.3
QT/DQT Decode
QT/DQT Decode is a function to wait for a specific call.
QT/DQT Decode facilitates communication within the
specified group when the same channel is sharing with
other groups. It will effects to exclude the other group
communication with muting. With this function, you can
communicate without listening to conversations of other
groups.
It is possible to configure the QT/DQT Decode code on
each channel by FPU.
TKR-750/850/751/851 unmutes audio when the received
QT/DQT matched and a received audio is transmitted
under repeat operating.
TKR-750/850/751/851 does not unmute when the
received QT/DQT does not matched and a received
audio is not transmitted if it is operating as Repeater.
You can use the QT/DQT Decode function of the Multi
Table at the same time in order to wait for a call.
4.7 Encode Tone in Multiple, 21 Multi-table.)
! Configuration of KPG-91D
" Configuring the QT/DQT Decode (Refer to FPRG
6.2.3 QT/DQT Decode.)
4.4
QT/DQT Encode
QT/DQT Encode is a function to make a Group call.
Encoding QT/DQT limits communication within the
specified group when the same channel is sharing with
other groups. Signals from other groups are muted. With
this function, you can communicate without listening to
conversations of other groups.
It is possible to configure the QT/DQT Encode code on
the each channel by FPU.
The configured QT/DQT Encode code is transmitted
while transmitting with audio continuously.
Note:
Function Reference (FUNC)
(Refer to 1.2 TX/RX Frequency.)
(Refer to
9
Advertisement
Table of Contents
