NEC Univerge SV8100 Features And Specifications Manual page 255

UNIVERGE SV8100
Caller ID information outputs on the SMDR report.

ANI/DNIS can use the Caller ID tables for routing. Refer to

Compatibility) on page 2-1329
The system can send Caller ID digits to the voice mail if allowed in Program 14-02-10.

When more than 20 characters are set in Program 20-20 : Message Setup for Non-Caller

ID Data, either the first or last character is missing (based on the entry in Program
20-19-01).
If Program 20-09-06: Class of Service Options (Incoming Call Service): Incoming Time

Display is set to 1 (On), the first line displays the time and date.
When you shut down the system, incoming history data is cleared. But you can back up the

history data by pressing Speaker +
Program 15-07-01 button (63) when enabled, removes the CPN from the setup message

when making an outbound ISDN call, this is a toggle enable/disable button and can be
used on a Call-by-Call basis. Programs 14-01-20, 14-01-21 and 20-08-15 are used for
copper trunks only and can be set only per trunk/Class of Service.
SLT users cannot block an incoming call based on the incoming Caller ID information on a

station-by-station basis.
The CD-CP00-US has 32 resources for DTMF receiving and Dial Tone detection. When a

is PZ-BS10 installed there are 64 resources available.
When Program 10-09-01 is set to 0 (Common) and Program 14-02-10 (Caller ID) is set to 1

(Yes), all DTMF/Dial Tone Detection resources are always allocated to analog trunks, not
analog extensions. However, if Program 14-02-10 (Caller ID) is set to 0 (No), all DTMF/Dial
Tone Detection resources can be used for both analog trunks and analog extensions.
Default Setting
Disabled
System Availability
Terminals
All multiline terminals with a display and Single Line Telephones equipped to receive Caller ID.
Caller ID
for more information.
9.
# #

T1 Trunking (with ANI/DNIS
Issue 5.0
2 - 229