Hitachi Compute Blade 500 Series User Manual page 225

Table 4-7 Controller properties submenu 2 items
Menu items
Battery Backup
1
Coercion Mode
2
Set Factory Defaults
3
S.M.A.R.T Polling
4
Cluster Mode
Alarm Control
3
Rebuild Rate
3
Patrol Read Rate
3
BGI Rate
3
Cache Flush Interval
3
CC Rate
3
Spinup Drive Count
3
Reconstruction Rate
3
Spinup Delay
3
NCQ
Notes:
1 This can be changed only when no disk arrays have been set at all.
.
2 Do not use Set Factory Defaults. This setting must be changed to the
.
recommended values.
3 Always use the "Default" setting.
.
4 Change the value to the recommended value.
.
Tip:
• When changing a setting value, select the text box, click it to open the
dropdown list, and select the value; or click the cursor on a setting value
to change, and type a new value from the keyboard. Then click Submit.
MegaRAID WebBIOS for storage expansion blades
Hitachi Compute Blade 500 Series EFI User's Guide
Description
Cache backup module mount
status
Sets the capacity control for
the physical hard disk used
for disk array building
Returns all the settings to
their Defaults values
Sets the interval of S.M.A.R.T.
reporting
Sets the cluster mode
Sounds the buzzer on the
controller in the event of a
fault at a connected device
Priority of rebuilding
Priority of patrol reading
Priority of background
initializing
Flash timing for write-cache
data
Priority of integrity inspection
Number of hard disk motors
started at system startup
Priority in expanding capacity
Hard disk spinup timing at the
system boot
Setting the NCQ command
Setting/display value
None/Present (See Battery
Module: BBU setting submenu on
page 4-16.)
[<<None (using the entire
capacity)>>] / 128MB-way (using
a capacity as a multiple of
128MB) / 1GB-way (using a
capacity as a multiple of 1GB)
-
0 to 65535 / <<300>> / [600]
[<<Disabled (invalid)>>]
[<<Disabled (not sounding)>>] /
Enabled (sounding) / Silence
(stop sounding temporarily)
0 to 100 / [<<30>>]
0 to 100 / [<<30>>]
0 to 100 / [<<30>>]
1 to 255 / [<<4>>]
0 to 100 / [<<30>>]
0 to 8 / [<<4>>]
0 to 100 / [<<30>>]
0 to xxx / [<<6>>]
[<<Enabled>>] / Disabled
4-15