Displaying Error Messages At The System Boot; Ending The Utility - Hitachi Compute Blade 500 Series User Manual

Displaying error messages at the system boot

When you need the following conditions, change Boot Error Handling settings.
• SAS 3004 iMR error messages should not appear at the system boot.
• Internal disk array controller should not be used.
If using N+M cold standby, change settings of the standby partition (server
blade).
This section describes how to change Boot Error Handling for disk array
controllers.
Note: When N+M cold standby is configured, the disk array embedded in a
server blade is not supported.
To prevent boot error messages
Follow the steps below to prevent boot error messages from appearing.
1 Select Controller Management from the Main menu, and press Enter.
.
2 Controller Management window appears.
.
Select Advanced and press Enter.
3 Advanced Controller Management window appears.
.
Select Boot Error Handling and press Enter.
4 Select one of the following values and press Enter.
.
Note: Make sure to select Stop on errors or Ignore errors. Never
select a value other than those shown below.
Menu items
Stop on errors
Ignore errors
5 Select Apply Changes and press Enter.
.

Ending the utility

This section describes how to end the Utility.
1 Press ESC several times on the Main Menu window to return to EFI Menu
.
main window.
5-46
Enables error messages at the system boot.
(Recommended value when a disk array controller is used.)
Disables error messages at the system boot.
(Recommended value when a disk array controller is not used.)
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
Description