Hitachi Compute Blade 500 Series User Manual page 47

Note: Do not change the settings of the following items. If you change the
settings, UEFI may not start up.
• Active Video
• PCI 64-Bit Resource Allocation
• MM Config Base
• Enable/Disable Onboard Device(s)
• Enable/Disable Adapter Option ROM Support
• Set Option ROM Execution Order
• PCIe Gen1/Gen2/Gen3 Speed Selection
• Console Redirection Settings
However, when 1 Gb 4-port/8-port LAN mezzanine card is installed in the
mezzanine card slot 4 of storage expansion blade, change configuration for
Enable/Disable Adapter Option ROM Support on page
Storage expansion blade settings on page
The following table shows description of menu items appeared in the left side
of the window.
Select an item to display or set, and press Enter.
Table 2-23 Device and I/O Ports sub menu items
Menu items
Active Video
PCI Express Native
Control
PCI 64-Bit Resource
Allocation
MM Config Base
Enable/Disable
Onboard Device(s)
Enable/Disable Adapter
Option ROM Support
Set Option ROM
Execution Order
PCIe Gen1/Gen2/Gen3
Speed Selection
Hitachi Compute Blade 500 Series EFI User's Guide
1
Selection
• <<Onboard
Device>>
• Add-in Device
• <<Disable>>
• Enable
• <<Disable>>
• Enable
• <<2 GB>>
• 1 GB
• 3 GB
-
-
-
-
UEFI setup menu
2-37. For details, see
2-37.
Description
Specifies a destination to output
video.
Enables or disables direct control of
PCI Express by OS. This item is
displayed with the server blade
firmware version 04-22 or later.
Enables or disables 64-bit resource
allocation to PCI device.
Sets a start address for PCI Express
configuration space.
Enables or disables onboard devices.
Enables or disables Legacy Option
ROM and UEFI Option ROM of PCI
device.
Sets execution order of Legacy
Option ROM of PCI device.
Selects PCIe speed available with
the PCI slot.
2-27