Hitachi Compute Blade 500 Series User Manual page 79

System Settings
Select an item to display or set, and press Enter.
Note: Do not change the settings of the following items. If you change the
settings, UEFI may not start up.
• Adapters and UEFI Drivers
• Devices and I/O Ports
• Operating Modes
• Legacy Support
• Storage
• Network
With the following system configuration, follow directions below.
• When installing 1 Gb 4-port/8-port LAN mezzanine card in the mezzanine
card slot 4 of a storage expansion blade, change the Devices and I/O
Ports configuration. For details, see
page
• For LSI Software RAID model, select Storage, and create and configure
RAID. See
arrays
The following table shows description of menu items appeared in the left side
of the window.
Menu items
Adaptors and UEFI
Drivers
Processors
Memory
Devices and I/O Ports
Operating Modes
Legacy Support
System Security
RAS Configuration
Storage
Network
2-71.
Chapter 6, LSI Software RAID Configuration Utility for disk
for details.
Table 2-53 System Settings menu items
Displays information about adapters and UEFI drivers on the
server blade.
Displays and provides option to change the processor settings.
See Processors sub menu on page
Displays and provides option to change the memory settings.
See Memory sub menu on page
Displays devices and I/O port options of settings.
Selects the operating mode desired based on your preference.
Selects the legacy support.
Selects the TPM setup options.
See System Security sub menu on page
Sets RAS configuration.
See RAS Configuration sub menu on page
Selects this option to see all the Storage Device options.
Selects the Network setup options
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide
Storage expansion blade settings on
Description
2-60.
2-61.
2-62.
2-63.
2-59