Hitachi Compute Blade 500 Series User Manual page 375

Message
The most recent configuration
command could not be committed
and must be retried.
Press any key to continue, or press
C to load the configuration utility.
There are more enclosures
connected to the port than what is
allowed for a single SAS port.
Remove the extra enclosures, and
then restart your system.
There are offline or missing virtual
drives with preserved cache.
Check the cables and ensure that
all drives are present.
Press any key to enter the
configuration utility.
There was a drive security key
error.
All secure drives is marked as
foreign.
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
Description
If this message is displayed even though an
incorrect power-off or reboot has not been
executed during write operation, contact your
reseller or call maintenance personnel.
Cause:
The disk array configuration information was
cleared or was not found.
Action 1:
a Enter a character, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.
The selection window appears.
c Press the Y key.
.
System startup continues.
Action 2:
a Press the C key, and then press the Enter
.
key.
b The LSI MegaRAID <HITACHI SAS 3004
.
iMR ROMB> Configuration Utility restarts.
Action 3:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
Incorrect enclosures were detected.
Action:
If this message appeared, contact your reseller
or call maintenance personnel.
In addition, if this message appeared, the
system startup cannot continue.
Cause:
Some logical drives are not recognized.
Action 1:
a Enter a character, and then press the Enter
.
key.
The LSI MegaRAID <HITACHI SAS 3004
iMR ROMB> Configuration Utility restarts.
Action 2:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
The hard disk security functionality is not
supported.
Action 1:
5-67