ABB i-bus KNX
© 2009 Busch-Jaeger Elektro GmbH – A Company of the ABB Group
Commissioning
Heating setpoint reduction night operation
Options:
- 0.5 K
- 1.0 K
- ...
- 4 K
- ...
- 8.0 K
The setting "Heating setpoint reduction night operation" allows you to
specify the number of degrees Kelvin that the comfort temperature is
lowered during night mode.
This parameter is only available if the parameter "Selection of base setpoint"
(tab "Setpoint general") is set to "dependent setpoints".
Heating setpoint standby mode
Options:
- 14.0 °C
- 14.5 °C
- ...
- 19.0 °C
- ...
- 29.0 °C
"Heating setpoint for standby mode" specifies the individual standby
temperature for heating mode. The temperature value specified does
not depend on the specified "Heating setpoint comfort mode".
This parameter is only available if the parameter "Selection of base setpoint"
(tab "Setpoint general") is set to "individual setpoints".
Heating setpoint night mode
Options:
- 10.0 °C
- 10.5 °C
- ...
- 15.0 °C
- ...
- 25.0 °C
The "Heating setpoint night mode" specifies the individual temperature
during the night for heating mode. The temperature value specified does
not depend on the specified "Heating setpoint comfort mode".
This parameter is only available if the parameter "Selection of base setpoint"
(tab "Setpoint general") is set to "Individual setpoints".
49