Special Operating States - ABB i-bus KNX Product Manual

Room thermostat fan coil with display

Hide thumbs Also See for i-bus KNX:

Table of Contents

ABB i-bus KNX

3.4

Special operating states

Commissioning

Behaviour after reset

The behaviour after reset can be set for the operating mode, the operating

type and the fan stage.

Heating, cooling and the state of the object "switching heating/cooling" can

be selected for the operating mode. When it is set to "depending on object

"switching heating/cooling"", the object state is queried via the bus when

switching on or after a reset.

Comfort mode is default after reset, however Standby, Night mode or

Frost/Heat Protection can also be selected.

The active fan stage after reset can be stage 1, 2 or 3. If no stage is to be

active after reset, select the setting "Off". The setting "Automatic" switches

on the fan stage in accordance with the current control value.

Table of Contents