ABB i-bus KNX
2.4
Assembly and installation
© 2009 Busch-Jaeger Elektro GmbH – A Company of the ABB Group
Technology
The Fan Coil with display ambient temperature controller is a surface-
mounted device (AP) with an integrated bus coupler. The device operates
without additional supply voltage. It can be installed on flush-mounted
sockets (UP) (VDE, China, British Standard).
Selection of a suitable installation location for the controller and suitable
parameter settings are essential for good temperature detection.
-
The ambient temperature
controller should be
installed approximately
150 cm above the floor
and 50 cm from the door
frame.
-
The ambient temperature
controller should be
installed on a wall opposite
the radiator.
-
The radiator and the
ambient temperature
controller must not be
separated by corners
in the room.
-
An ambient temperature
controller should not be
installed near a radiator
or behind curtains.
-
It should also not be
installed on an exterior
wall - low outside
temperatures will
influence the temperature
regulation.
8