Adjustment - ABB i-bus KNX Product Manual

Room thermostat fan coil with display

Hide thumbs Also See for i-bus KNX:

Table of Contents

4.2.4

Adjustment

The room temperature controller will stop controlling and will send a

predefined control value ("control value for temperature measurement error")

to prevent the room from overcooling or overheating. The control value is

transmitted until the ambient temperature controller receives a temperature

telegram over the bus again and the control is enabled again.

If the measured temperature is falsified, for example by the internal heat

of the bus coupler, an "ambient temperature adjustment value" can be set.

If an additional external temperature sensor has been enabled and the

measured value is falsified by cold or heat influences, an adjustment value

can also be set.

Table of Contents