Parameters; Parameter Window "General - ABB i-bus KNX Product Manual

ABB i-bus KNX
3.2

Parameters

3.2.1 Parameter window
"General"
© 2009 Busch-Jaeger Elektro GmbH – A Company of the ABB Group
Commissioning
Send "In operation" object
Options: - No
- Send value "0" cyclic
- Send value "1" cyclic
The "In operation" object reports to the bus that the device is operating
correctly. This periodic message can be monitored by an external device.
The following parameters are shown:
transmission period in s [1...65.535]
Options: - 1...60...65.535
The period at which the "In operation" object sends a message
periodically is set here.
Enable switchover of temperature display via button °C/°F
Options: - Yes, standard °C
- Yes, standard °F
- No, standard °C
- No, standard °F
This parameter enables the °C/°F push-switch. The user can then switch
the temperature display from °C to °F. The temperature is always converted
from °C to °F in the Fan Coil ambient temperature controller with display,
because only °C values can be sent to the KNX.
If the "No" setting has been made, the °C/°F push-switch has no function
and the user cannot change the display.
13