Monitoring - ABB i-bus KNX Product Manual

ABB i-bus KNX
3.3.7

Monitoring

© 2009 Busch-Jaeger Elektro GmbH – A Company of the ABB Group
Commissioning
No. Function
37 Receive in operation
The object is visible if the corresponding parameter is set to "yes".
This object monitors the cyclic sending of the actuator "In use" communication object.
If monitoring is triggered, the "fault" symbol (plus text display) is shown on the display
(it disappears automatically).
39 Signal dew point
This 1-bit communication object should be used to send telegrams from a dew point sensor
that, for example, is connected to a binary input. If the object receives an ON telegram, heat
protection is enabled; if the object receives an OFF telegram, heat protection is disabled.
This data item forms the 1-byte KNX object and can be received only. The action depends
on the parameterisation.
40 Signal condensate tank
This 1-bit communication object should be used to send telegrams from a dew point sensor
that, for example, is connected to a binary input. If the object receives an ON telegram, heat
protection is enabled; if the object receives an OFF telegram, heat protection is disabled.
This data item forms the 1-byte KNX object and can be received only. The action depends
on the parameterisation.
Object name Data type
Actuator monitoring 1 bit
Dew-point monitoring 1 Bit EIS1
DPT 1.001
Monitoring of 1 Bit EIS1
condensate tank DPT 1.001
Flags
K, S
K, S
K, S
76