Table of Contents
Advertisement
5. Monitoring and Configuring the Printer
View Setting
msh> ipv6
IPv6 stateless address
msh> ipv6 stateless {on|off}
If "on" is selected, IPv6 requests information required for maintaining stateful connection to the router
for as long as the printer power is turned on. This setting allows information from the router to be
obtained constantly, and periodically refreshes the effective period of the stateless address.
logout
Use the "logout" command to save the changes and quit telnet.
Quit telnet
5
msh> logout
A confirmation message appears.
{yes|no|return}
Enter [yes], [no] or [return] by typing the word, and then press the [Enter] key.
To save the changes and quit telnet, enter [yes].
To discard the changes and quit telnet, enter [no].
To continue making changes, enter [return].
lpr
Use the "lpr" command to view and configure LPR settings.
View Setting
msh> lpr
Checking host name when deleting the job
msh> lpr chkhost {on|off}
• The default is "on".
If "on" is selected, you can delete print jobs only from the IP address of the host that sent the print job.
If LPR is disabled, you can also delete print jobs sent from IP addresses other than that of the host.
Printer Error Detection Function
lpr prnerrchk {on|off}
• The default is "off".
If you set this to "on", the printer stops receiving data and will wait until the error is resolved before
continuing processing a job.
190
Advertisement
Table of Contents
