1. System Settings
Programming the LDAP server
This section describes how to specify the LDAP server settings.
1
This function supports LDAP version 2.0 and 3.0.
Program the LDAP server to find e-mail destinations in the LDAP server Address Book directly.
This function is possible when sending scan files by e-mail using the scanner.
To start a LDAP search, make sure that the items listed below are set. For other items, check your environment
and make any necessary changes.
• Server Name
• Search Base
• Port Number
• Authentication
• Search Conditions
If [Kerberos Authentication] is selected be sure to set the "User Name", "Password", and the "Realm Name".
If [Digest Authentication] or [Cleartext Authentication] is selected be sure to set the "User Name" and
"Password".
To use the LDAP server in Administrator Tools, select [On] under "LDAP Search".
The LDAP version 2.0 does not support Digest Authentication.
To select Kerberos Authentication, a realm must be registered in advance.
Programming the LDAP server
This section describes how to program the LDAP server.
1.
Press the [User Tools] key.
2.
Press [System Settings].
3.
Press [Administrator Tools].
4.
Press [ Next].
5.
Press [Program / Change / Delete LDAP Server].
6.
Check that [Program / Change] is selected.
7.
Select the LDAP server you want to program or change.
When programming the server, select [*Not Programmed].
8.
Press [Change] right "Name".
9.
Enter the name, and then press [OK].
10.
Press [Change] right "Server Name".
52