Table of Contents
Advertisement
1. System Settings
The default setting is [Normal].
Key Repeat
You can enable or disable repetition of an operation if a key on the screen or control panel is pressed
1
continuously.
The keys affected by the key repeat setting can vary depending on the selected function.
The default setting is [Normal].
Z-fold Position
You can adjust the position of the lines of the Z-fold in steps of 1 mm.
Paper size
A3
11 × 17
B4JIS, A4, 8
11, Others
Half Fold Position
You can adjust the position of the lines of the half fold in steps of 1 mm.
Paper size
A3, B4JIS, A4, 11 × 17,
1
8
/
× 14, 8
2
Letter Fold-out Position
You can adjust the position of the lines of the letter fold-out in steps of 1 mm.
When you specify multifold, you cannot change the positions of the folds. Any adjusted settings will
be cleared if you press [OK] when prompted to select multifold.
Paper size
A3, B4JIS, A4, 11 × 17,
1
8
/
× 14, 8
2
Letter Fold-in Position
You can adjust the position of the lines of the letter fold-in in steps of 1 mm.
22
2 – 25 mm
(0.1 in. – 1.0 in.)
2 – 20 mm
(0.1 in. – 0.8 in.)
1
1
/
× 14, 8
/
×
2 – 17 mm
2
2
(0.1 in. – 0.7 in.)
-10 – 10 mm
1
/
× 11, Others
2
(-0.4 – 0.4 in.)
-10 – 10 mm
1
/
× 11, Others
2
(-0.4 – 0.4 in.)
Setting ranges
2 mm (0.1 in.)
Setting ranges
0 mm (0 in.)
Setting ranges
4 mm (0.2 in.)
Factory-set values
Factory-set values
Factory-set values
Advertisement
Table of Contents
