Table of Contents
Advertisement
8. Appendix
Configuring IEEE 802.1X
IEEE 802.1X can be configured using Web Image Monitor's administrator mode. You can select four types
of EAP authentication method: EAP-TLS, LEAP, EAP-TTLS and PEAP. Note that each EAP authentication
method has different configuration settings and authentication procedures.
Types and requirements of certificates are as follows:
If a certificate is required, configure all settings after installing the certificate.
EAP Types Requiring a "Site Certificate"
EAP-TLS, EAP-TTLS, PEAP (Necessary except LEAP)
EAP Types Requiring a "Site Certificate" and a "Device Certificate"
EAP-TLS, PEAP (Phase 2 is for TLS only)
• To set IEEE 802.1X, you must enable SSL. For details about setting SSL configuration, see "Protection
Using Encryption", Security Reference.
• To set IEEE 802.1X, you must use Web Image Monitor.
Installing a Site Certificate
1.
Access the authentication server and obtain the CA certificate.
8
Methods of obtaining certificates differ according to the operating system you are using.
2.
Log on to Web Image Monitor in the administrator mode.
3.
Click [Configuration].
4.
[Site Certificate] in the "Security" area.
5.
Click [Browse] on the "Site Certificate to Import" window, and then select the CA certificate
you obtained.
6.
Click [Import].
7.
Check that the imported certificate's [Status] shows "Trustworthy".
If [Site Certificate Check] shows [Active], and the [Status] of the certificate shows [Untrustworthy],
communication might not be possible.
8.
Click [OK].
9.
Click [Logout].
10.
Quit the Web Image Monitor.
364
Advertisement
Table of Contents
