Patient-Configurable Settings in Telemetry Setup
Control
Function
SpO
Enable/disable the SpO2
2
Enabled
measurement at the Information
Center or Telemon.
SpO
Mode
Determine the transceiver SpO
2
behavior.
Note—
are not available in Spot Check.
Draft - 1 Aug 08
Pulse Rate and Pleth Wave
Telemetry Functions at the Information Center & TeleMon
Telemetry Functions at the Information Center
Setting Choices
enable
disable
Spot Check - Provides
2
manual measurements so the
clinician can check as
needed. Measurement
initiated by plugging the
SpO
cable into the
2
transceiver or by selecting
the Spot Check SpO
the Patient Window. No
pulse or successful/failed
measurement tones are
generated when
measurement is initiated at
Information Center.
Continuous - Sends an SpO
parameter value to the
Information Center every
second. If selected, Pulse
Rate and Pleth Wave may
also be sent.
Factory
Default
enable
Spot Check
icon in
2
2
9-7