Mitsubishi Electric F700 Instruction Manual page 225

Setting from the parameter unit, operation panel
(1) Using the setting dial like a volume to set the frequency.
Operation example Changing the frequency from 0Hz to 50Hz during operation
1.
Screen at powering on
The monitor display appears.
2.
Press
mode.
3.
Press
setting mode.
4.
Turn until
5.
Press to read the currently set value.
" " (initial value) appears.
6.
Turn counterclockwise to change it to
the setting value of "
7.
Press to set.
8.
Change Pr. 161 to the setting value of "
in the similar manner. (Refer to step 4 to 7.)
9.
Mode/monitor check
Press twice to choose
monitor/frequency monitor.
10.
Press (or
11.
Turn clockwise until "50.00" appears.
The flickering frequency is the set frequency.
You need not press
REMARKS
⋅ If the display changes from flickering "50.00" to "0.00", the setting of Pr. 161 Frequency setting/key lock operation selection may
not be "1".
⋅ Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning the dial.
⋅ When the frequency is changed, it will be stored in EEPROM as the set frequency after 10s.
218
Operation
to choose the PU operation
to choose the parameter
(Pr. 160) appears.
".
) to start the inverter.
.
Display
PU indication is lit.
Flicker ··· Parameter setting complete!!
"
Flicker ··· Parameter setting complete!!
The frequency flickers for about 5s.
The parameter number
previously read appears.