Parameter Copy - Mitsubishi Electric F700 Instruction Manual

Parameter copy

3.24 Parameter copy
Multiple inverters and parameter settings can be copied.
Operation
1.
Connect the operation panel to the
copy source inverter.
• Connect it during a stop.
2.
Press to choose the parameter
setting mode.
3.
Turn until
appears.
4.
Press to to read the currently set value.
" "(initial value) appears.
5.
Turn clockwise to change it to
the setting value of " ".
6.
Press to copy the source parameters
to the operation panel.
7.
Connect the operation panel to the
copy source inverter.
8.
After performing steps 2 to 5,
turn clockwise to change
it to " ".
9.
Press to write the parameters copied to
the operation panel to the destination inverter.
10.
When copy is completed,
" " and "
11.
After writing the parameter values to the copy
destination inverter, always reset the inverter,
e.g. switch power off once, before starting operation.
appears...Why?
appears...Why?
and
Appears when parameters are copied between the inverter of 01160 or less and 01800 or more.
1. Set "0" in Pr. 160 User group read selection.
2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.
Pr. 989 Setting
3. Reset Pr.9, Pr.30, Pr.51, Pr.52, Pr.54, Pr.56, Pr.57, Pr.61, Pr.70, Pr.72, Pr.80, Pr.90, Pr.158, Pr.190 to
Pr.196, Pr.893.
PCPY Setting
0 Cancel
1 Copy the source parameters to the operation panel.
Write the parameters copied to the operation panel into
2
the destination inverter.
Verify parameters in the inverter and operation panel.
3
(Refer to page 223.)
222
(parameter copy)
About 30s later
" flicker.
Parameter read error. Perform operation from step 3 again.
Parameter write error. Perform operation from step 8 again.
flicker alternately
01160 or less
10
Description
Display
Flicker ··· Parameter copy complete!!
Flicker ··· Parameter copy complete!!
01800 or more
100
REMARKS
· When the copy destination inverter is not the FR-
F700 series, "model error (
· Refer to the extended parameter list on the
Instruction Manual (basics)
parameter copy.
The parameter
number previously
read appears.
The frequency flickers
for about 30s
The frequency flickers
for about 30s
)" is displayed.
for availability of