Siemens SINAMICS G120 Operating Instructions Manual page 283

Parameter
p11065
p11067
p11068
p11071
p11074
p11080
p11085
p11091
p11092
r11094
You can find the complete parameter list in the List Manual.
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
Remark
Free tec_ctrl 0 actual value smoothing time constant (Factory setting: 0 s)
Free tec_ctrl 0 actual value upper limit (Factory setting: 100 %)
Free tec_ctrl 0 actual value lower limit (Factory setting: -100%)
Free tec_ctrl 0 actual value inversion (Factory setting: 0)
0: No inversion
1: Inversion
Free tec_ctrl 0 differentiation time constant (T
Free tec_ctrl 0 proportional gain (K
Free tec_ctrl 0 integral time (T
CO: Free tec_ctrl 0 maximum limit (Factory setting: 100 %)
CO: Free tec_ctrl 0 minimum limit (Factory setting: 0 %)
CO: Free tec_ctrl 0 output signal
6.19 Free technology controllers
) (Factory setting: 0 s)
d
) (Factory setting: 1.0)
P
) (Factory setting: 30 s)
I
Advanced commissioning
283