Siemens SINAMICS G120 Operating Instructions Manual page 545

J
JOG function, 249
K
Kinetic buffering, 346
Know-how protection, 370, 389
KTY84 sensor, 325
L
LED
BF, 396, 397
LNK, 396
RDY, 396
LED (light emitting diode), 395
Level control, 274
License, 370
Line and motor connection, frame sizes
FSD ... FSF, 95, 104
Line dip, 346
Line filter, 43
Linear characteristic, 300, 301
List Manual, 537
LNK (PROFINET Link), 396
Low Overload, 438
M
Manual mode, 250
Maximum cable length
PROFIBUS, 141
Maximum cable lengths
PROFINET, 138
Maximum current controller, 321
Maximum speed, 152, 266
MELD_NAMUR (fault word according to the VIK-
Namur definition), 225
Memory cards, 370
Menu
BOP-2, 525
Operator panel, 525
Minimum speed, 152, 266, 269
Mistakes manual, 541
MMC (memory card), 370
MOP (motorized potentiometer), 261
MotID (motor data identification), 158, 164, 166, 170
Motor code, 148
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
Motor control, 192
Motor data, 147
Identify, 158, 170, 308
Identifying, 164, 166
measure, 158, 170
Measuring, 164
Motor fault, 434
Motor standard, 253
Motor temperature sensor, 113, 326
Motorized potentiometer, 261
Multi-zone control, 284
O
OFF1 command, 210
OFF3 ramp-down time, 272
ON command, 210
Operating instruction, 25
Operating Instructions, 537
Operation, 196
Operator panel
BOP-2, 525
Installing, 153
Menu, 525
Optimizing the closed-loop speed controller, 308
Output reactor, 296
Overload, 321
Overview
Section, 26, 27
Overview of the functions, 191
Overvoltage, 331
P
Page index, 228
Parabolic characteristic, 300, 301
Parameter channel, 226
IND, 228
Parameter index, 228
Parameter number, 228, 528
Parameter value, 528
Partial load operation, 509
PID controller, 274
PKW (parameter, ID value), 217
PLC functionality, 535
Power failure, 342
Power Module, 30
Pressure control, 274
Procedure, 25
PROFIBUS, 141
PROFIdrive, 137
Index
545