NEC SL 1000 Programming Manual page 124

SL1000/SL1100
Item
No.
07
Program
14
08
09
10
11
12
13
16
18
19
20
Conditions
None
2-102
Downloaded from www.Manualslib.com
Item
DP to DTMF Conversion Op- 0 = Automatic
tions 1 = Automatic and Manual
Determine how a user can con- 2 = Manual
vert a Dial Pulse (DP) call to a
DTMF call. For each trunk, set
the type of DP to DTMF conver-
sion required. There are three
conversion options: Automatic
(0), Automatic and Manual (1),
or Manual (2).
Automatic:
DP to DTMF conversion occurs
automatically if the extension
user waits more than 10 sec-
onds before dialing the next
digit.
Automatic and Manual:
DP to DTMF conversion occurs
automatically if the extension
user waits more than 10 sec-
onds before dialing the next
digit. In addition, the user can
dial # to switch a DP trunk to
DTMF dialing.
Manual:
Users can dial # to switch a DP
trunk to DTMF dialing.
Answering Condition 0 = Polarity Reversing
(Polarity)
1 = Polarity Reversing or
Timer (Int Digit)
Busy Tone Detection 0 = Disable (No)
1 = Enable (Yes)
Caller ID 0 = No
Enable or disable a trunk ability 1 = Yes
to receive Caller ID information.
Next Trunk in Rotary if No 0 = Disable (No)
Dial Tone 1 = Enable (Yes)
Use this option to enable/
disable the system ability to
skip over a trunk if dial tone is
not detected. This option per-
tains to calls placed using
Speed Dial, ARS, Last Number
Redial or Save Number dialed.
It does not pertain to line key or
Direct Trunk Access calls.
Detect Network Disconnect 0 = Disable (No)
Signal 1 = Enable (Yes)
Trunk-to-Trunk Limitation 0 = Disable (No)
1 = Enable (Yes)
Caller ID Type 0 = FSK
1 = DTMF
Busy Tone Detection on Talk- 0 = Disable
ing 1 = Enable
Busy Tone Detection Fre- 1 ~ 255
quency
Busy Tone Detection Interval 0 ~ 64800 (x 100 ms)
manuals search engine
Input Data Default
2
1
0
0
0
0
0
0
0
1
0
Program 14 : Trunk, Basic Setup
ISSUE 1.0
Related Pro-
Note
gram
21-01-03
21-01-03
14-02-18
14-02-18