ABB PSTX30 Installation And Commissioning Manual page 31

Mounting Detachable HMI
4.2.6.1
A cable is included in the shipment, but it is also
possible to use your own RJ45 network cable.
The cable length should be max 3m long to
minimize distortion of the communication.
The softstarter HMI is IP66 approved when
mounted on the enclosure door.
The detachable HMI can also be used to copy parameters
from one softstarter to another during commissioning
(temporarily handheld).
Included with the softstarter comes:
• Rubber gasket
• Plastic screw-nut
• RJ45 Network cable
1. Remove the detachable HMI from the softstarter by
unsnapping the plastic latch under the detachable
in Figure 20.
HMI, see 1 and 2
2. Drill a hole were the detachable HMI is to be
mounted. Maximum size of the hole is Ø26
(Ø 1.02"), see in Figure 21. Put the rubber
1
packing around the threaded network connector on
the detachable HMI, see
the threaded network connector through the drilled
hole.
See 3 in Figure 21. Fasten the plastic screw-nut
on the threaded network connector, with 2 Nm
(17.7 lb/in).
3. Remove the RJ45 plug see
the network cable to the network port on the front
of the softstarter in Figure 21.
5
4. Connect the other end of the network cable to the
network port on the back of the detachable HMI,
see in Figure 22.
6
5. Make sure that the network cable is properly
inserted into both ports. Roll the rest of the
hanging cable so it will not get clamped by the
in Figure 23. Close the door of the
door, see 7
enclosure and switch on the operational voltage to
control that the external HMI is working.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
in Figure 21. Press the
2
. Connect one end of
4
20
1
2 Nm (17,7 lb.in)
Figure 20: Drill a hole for the detachable keypad.
21
Figure 21: Connect one end of the network cable.
22
6
Figure 22: Connect the other end of the network cable.
23
7
Figure 5: Roll the rest of the hanging cable.
2
3
Ø26 (Ø 1.02")
5
4
4