ABB PSTX30 Installation And Commissioning Manual page 47

6.1.2 Keypad
The softstarter has 10 keys on the keypad,
see Figure 46. This chapter describes the function of
each key.
Selection softkeys
The Selection softkeys normally have more than one
function, such as selecting, exiting, changing and storing,
depending on present dialogue. The display above the key
shows the current softkey function. See
Navigation keys
The Navigation keys are used for navigating in the menu
and change the parameter values. A menu/value that
are highlighted black in the display can be changed or
scrolled. When selecting from a list, the scrolling is done
in a closed loop. See 2 in Figure 46.
R\L-key
R\L-key stands for Remote or Local. This key gives you
the option to switch the control of the softstarter between
local control from the HMI and remote control
from hardwire input or fieldbus. See
i-key
The i-key is an information key for the HMI, and provides
context related information about the softstarter status
and settings.
Press this key for help and general information about the
current setting in the HMI. See
Stop key
The Stop key is the stop switch for the softstarter.
By pressing this key the motor will stop according to set
parameters. It is possible to press stop command during
the start ramp if required. (Only active in local control
mode). See 5 in Figure 46.
Start key
The Start key is the start switch for the softstarter.
By pressing this key the motor will start and operate
according to the set parameters. (Only active in local
6
control mode). See in Figure 46.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
1
in Figure 46.
3 in Figure 46.
4
in Figure 46.
46
Options
L N
100-250V
50/60 Hz K4 K4 K4 Start Stop Reset In1 In2 DGND DND +24V GND
PSTX
3
Stop
5
Figure 46: Keypad
Table 2
Keypad, Figure 46
Position Key
1
Selection softkeys
2
Navigation keys
3
R\L-key
4
i-key
5
Stop key
6
Start key
1
Menu
1
2
4
Start
6
6