Table of Contents
Advertisement
Installation of this unit
5
Check the positions of the clutch release arms
of the Bottom Module.
≥ Check that the left and right clutch release arms are
pulled out to the engage line.
≥ If the clutch release arms have not been pulled out to
the engage lines, pull the release arms out to the
engage lines.
6
Check the changer unit installation.
≥ Confirm that the changer unit is correctly installed in
the Bottom Module. Confirm that a 0.09 mm (0.004q)
gap gauge cannot be inserted between the four
changer unit seats at the front and back and the
bottom panel of the Bottom Module.
You can check the front through the
opening if the seats of the changer unit
are in contact with the bottom panel.
≥ It will be necessary to perform the tasks to install the
changer unit in the Bottom Module if a 0.09 mm
(0.004q) gap gauge can be inserted. Refer to
"Appendix A: Installing a changer unit" (
procedure.
Preparatory work for installation
59) for the
18
Advertisement
Table of Contents
