Table of Contents
Advertisement
Installation of this unit
5
Connect the left gear rack on the interface side.
≥ Insert your hand into the opening at the bottom panel
side and turn the left handle counterclockwise to raise
the gear rack.
≥ Allow the rack to rise until there is no gap between the
Base Module and the gear rack and then turn the left
clamping lever clockwise to secure it.
Clamping lever
Left handle
≥ Check the connection of the left gear rack on the
interface side.
If it is difficult to check the interface side, it is possible
to temporarily remove the Control Unit or the Writer
Unit. (
40)
≥ If it is difficult to check directly with eyesight, use an
inspection mirror, etc., to check the connection.
6
Turn on the drive transmission of the changer
unit.
≥ Pull the clutch release arm.
≥ Check that the left and right clutch release arms are
pulled out to the engage line.
Release Clutch
(Service)
Installation
Engage Clutch
(Default/Shipping)
29
7
Use a 0.09 mm (0.004q) gap gauge to check the
connection of the gear racks.
≥ Insert a 0.09 mm (0.004q) gap gauge between all of
the module connections on the left and right gear racks
on the interface side and the gear rack on the drawer
side, checking that they are all connected without
gaps.
Gap
under 0.09 mm
(0.004q)
0.09 mm (0.004q) gap
gauge can enter.
1 Release the connection of the gear rack. (
2 Push the gear rack of the uppermost module down
and secure the screws where it is stopped. (
3 Redo the tasks in "Connecting the gear rack" (
0.09 mm (0.004q) gap
gauge can enter.
Check the front and back locations of the
two modules above and below the place
where there is a gap in the gear rack.
(
30 to 32)
Checks on 30 to 32
are OK.
The problem is caused by a fault with
the module, so contact the vendor.
No
Yes
34)
21)
27).
No
Yes
ACCEPT
No
Check the Error
Yes
flow chart on 30
to 32.
Advertisement
Table of Contents
