Table of Contents
Advertisement
Installation of this unit
9
Paste the supplied cushion sheets 1 to 4 onto
the Base Module or Extension Module.
≥ This step is not required for the module to be placed at
the top.
≥ Paste the cushion sheets so that there is no gap
between the paste surface and each sheet.
≥ Smooth the cushion sheets firmly into place. If the
adhesion is insufficient, the cushion sheets may come
off when inserting the module.
Interface
side
1 Position and smooth cushion sheet 1.
Smooth the sheet referring to the dotted line below and
do not overhang the left, right and back sides or the
drawer side panel.
Interface
side
2 Position and smooth cushion sheet 2.
Position and smooth the sheet firmly referring to the
dotted line below and do not leave a gap between the
cushion sheet 1.
Interface
side
Preparatory work for installation
Cushion sheet 4
Cushion sheet 3
Cushion sheet 2
Cushion sheet 1
Cushion sheet 1
Cushion sheet 2
Cushion sheet 1
3 Position and smooth the left cushion sheet 3.
Ensure the drawer side of cushion sheet 3 meets the
drawer side line of cushion sheet 2. Smooth the sheet
firmly and do not leave a gap between cushion sheets 2
and 3. Straighten the cushion sheet 3 and smooth it to
fill the gap in the joint.
Gap in the joint
Interface
side
Drawer
side
4 Position and smooth cushion sheet 4.
Smooth the sheet firmly referring to the dotted line
below and do not leave a gap between the cushion
sheet 3.
Interface
side
5 Position and smooth the right cushion sheet 3.
Position and smooth the right cushion sheet 3 in the
same manner as the left cushion sheet 3 (refer to 3
above) so that no gaps are left between the right
cushion sheet 3 and the cushion sheets 2 and 4.
22
Cushion sheet 3
Cushion sheet 2
Cushion sheet 4
Cushion sheet 3
Advertisement
Table of Contents
