Table of Contents
Advertisement
Installation of this unit
≥ Check that the gear rack of the Bottom Module is lower
than the module's border line. If it is not lower than the
border line, turn the right handle counterclockwise to
lower the gear rack below the border line.
Drawer side
Right side of the interface side
8
Remove the module holder bracket.
≥ Remove the M5 screws and M5 cage nuts that hold
the module holder bracket.
Installation
Border line of the module
Border line of the module
9
Remove the top panel of the topmost module.
≥ Remove four thumbscrews and one M3 screw.
≥ Depending on the system configuration or installation
location, this step must be performed with both hands
at an elevated height. Ensure that the work area is
safe and be careful not to stumble over objects or fall
from the area.
10
Remove the securing screw of the gear rack of
the Base Module or Extension Module.
≥ Remove the securing screws of the gear rack of all
modules except the module to be installed on the top.
≥ Store the securing screws you have removed. These
will be required for transport.
Left gear rack on the
interface side
Right gear rack on
the interface side
Gear rack on the drawer side
36
Top panel
Interface side
Interface side
Interface side
Advertisement
Table of Contents
