Table of Contents
Advertisement
Installation of this unit
Installation
Checking the configuration
Example of installation
Extension Module
(with the Writer Unit)
Base Module
(LB-DH70A)
Bottom Module
(LB-DF81)
[Minimum configuration]
Check the configuration of DATA ARCHIVER that you are
installing.
≥ Be sure to place the Bottom Module at the bottom.
(Excluding the power supply, however)
≥ When adding Extension Modules (with the Writer Unit),
they need to be added in increments of two.
≥ Magazines are transported faster when the Writer Units
are placed on top of each other. (Example: Place them
at the second and third levels or fourth and fifth levels.)
≥ From a performance perspective, in a configuration with
2 or more Extension Modules (without the Writer Unit),
the Base Modules and Extension Modules (with the
Writer Unit) should be located in the middle. (Refer to
the rightmost diagram)
≥ Note: It is necessary to place the modules into the
racks in order, starting from the bottom, to make the
installation work easier. When installing the TDK-
Lambda DC12 V/24 V power supply unit on the very
bottom, install it first into the rack.
(LB-DF72A)
TDK-Lambda DC12 V/24 V
power supply unit
Extension Module
(without the Writer Unit)
(LB-DH82)
Base Module
(LB-DH70A)
Bottom Module (LB-DF81)
24
TDK-Lambda
DC12 V/24 V
power supply unit
Extension Module
(with the Writer
Unit)
(LB-DF72A)
Extension Module
(without the Writer
Unit)
(LB-DH82)
Advertisement
Table of Contents
