Table of Contents
Advertisement
Installation of this unit
2
Elevate the changer unit.
≥ Slowly lift part
of the changer unit within the guide
A
range.
≥ Take care when doing so, as the changer unit may
separate from the Bottom Module if you lift beyond the
upper limit of the guide range.
≥ Make sure that you are holding the designated parts of
the rear of the changer unit with the pads of the fingers
of both hands while lifting.
≥ Note: Do not grip the designated parts of the rear of
the changer unit too strongly. There is danger of your
fingers getting caught.
Upper limit of guide range
Guide range
Designated
parts
Appendix
Wear gloves
to prevent
injury.
Rear of changer unit
60
≥ Note: Do not lift by inserting your fingers in the holes
above the designated parts. There is danger of your
fingers getting caught.
≥ Lower the changer unit slowly.
3
Secure the gear rack.
≥ Turn the left handle clockwise until it stops.
≥ Turn the right handle counterclockwise until it stops.
≥ Confirm that the lowermost part of protruding part
in contact with the end of the slit in the Bottom Module.
Left handle
Slit
Protruding part
A
Slit end
is
A
Right handle
Advertisement
Table of Contents
