Table of Contents
Advertisement
Installation of this unit
Preparation of the Base and Extension Modules
1
Remove the top panel of the Base Module
(LB-DH70A).
≥ Remove four thumbscrews and one M3 screw.
2
Unlock all magazine drawers.
≥ Insert your hand in the module and then push the
unlock lever.
≥ When unlocked, the magazine moves slightly.
Drawer side
Preparatory work for installation
Top panel
Unlock lever
19
3
Draw the magazine drawer.
≥ Hold the handle of the magazine drawer with one hand
and pull it, and while supporting the bottom of the
magazine drawer with the other hand, pull it
completely out.
≥ The lower front part of the bottom magazine drawer on
each side has a convex shape, so place the drawer
vertically, not horizontally.
Vertically placed
Convex
part
≥ Before drawing out the magazine drawer, make sure to
unlock it. Drawing out the magazine drawer by force
may cause damage to it.
≥ Do not draw out the magazine drawer too hard.
≥ Do not put your hand in the unit from the opening of the
magazine drawer.
≥ Do not step on, hang from, or lean against the
magazine drawer, or perform any other actions that
result in applying too much force on it.
≥ Do not leave the magazine drawer pulled out.
Handle
Horizontally placed
Advertisement
Table of Contents
