Table of Contents
Advertisement
Installation of this unit
≥ Use flat washers, spring washers, and nuts to attach
the round terminals of the DC cable to the power
supply bus bar.
The flat washers, spring washers, and nuts are
supplied with the power shelf racks.
Bus bar
1 Flat washer
2 DC cable
Power supply installation
3 Spring washer
4 Nut
5 Tighten with the nut
driver for Hex Nut M6.
2
Attach the bus bar protection cover to the
power shelf rack.
1 Protection cover
2 Secure with the clip.
3 Attach the covers to both sides.
3
Check whether connections are correct.
≥ Important: Have the connections checked by multiple
workers to ensure that the "i" (plus voltage) and "j"
(GND) terminals are correctly connected.
45
Advertisement
Table of Contents
