Table of Contents
Advertisement
Parameterizing/addressing
9.4 Description of parameters
AA.FACT1 - Factor 1
Adjustment range:
Purpose:
Factory setting:
Ab.FACT2 - Factor 2
Adjustment range:
Purpose:
Factory setting:
AC.FACT3 - Factor 3
Adjustment range:
Purpose:
Factory setting:
180
0.1 ... 100.0
Use this sub-parameter to set the factor for the formation of limit
threshold 1.
Set the factor in a range from "0.1" to "100.0". The limit threshold
is the product of the reference stroke time and "AA.FACT1". De-
termining the reference stroke time is described under "A9.PSTIN".
The threshold 1 error message is displayed when the limit thresh-
old 1 is exceeded. The procedure to activate and display this error
message is described in the "XDIAG" parameter.
1.5
0.1 ... 100.0
Use this sub-parameter to set the factor for the formation of limit
threshold 2.
Set the factor in a range from "0.1" to "100.0". The limit threshold
is the product of the reference stroke time and "Ab.FACT2". De-
termining the reference stroke time is described under "A9.PSTIN".
The threshold 2 error message is displayed when the limit thresh-
old 2 is exceeded. The procedure to activate and display this error
message is described in the "XDIAG" parameter.
3.0
0.1 ... 100.0
Use this sub-parameter to set the factor for the formation of limit
threshold 3.
Set the factor in a range from "0.1" to "100.0". The limit threshold
is the product of the reference stroke time and "AC.FACT3". De-
termining the reference stroke time is described under "A9.PSTIN".
The threshold 3 error message is displayed when the limit thresh-
old 3 is exceeded. The procedure to activate and display this error
message is described in the "XDIAG" parameter.
The positioner responds in accordance with the option set in the
sub-parameter "A7.FLBH" - Behavior after failed PST".
5.0
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12
Advertisement
Table of Contents
