5. Tighten the screw
6. Connect the cables of each switch to the lug of the printed circuit board in pairs. Use the
provided cable ties
①
②
③
Figure 5-10
5.2.2
Device 6DR5..0/1/2/3-0E/D/F/G/K
5.2.2.1
Breakdown of the article numbers 6DR5..0/1/2/3-0E/D/F/G/K
Table 5- 4
Article No.
6DR5..0/1/2/3
6DR5..0/1/2/3-0E
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12
①
of the transparent cover
③
for this purpose.
Screw
Cover
Cable tie
Connecting the cables
Breakdown of the article numbers
Selection and ordering data
SIPART PS2 electropneumatic positioner in Makrolon, aluminum and stain-
less steel enclosure
6DR50
2-wire (4 to 20 mA) > without HART >
6DR52
2-, 3-, 4-wire (0/4 to 20 mA) > with HART, explosion-proof >
6DR5.1
For single-action actuator >
6DR5.2
For double-action actuator >
6DR5..0
Makrolon enclosure >
6DR5.11
Aluminum enclosure, narrow, only single-action >
6DR5..2
Stainless steel enclosure >
6DR5..3
Aluminum enclosure >
Type of protection (ATEX/IECEx): intrinsic safety
②
.
Connection
5.2 Electric
81