Siemens 6DR50 Series Operating Instructions Manual page 44

Installing/mounting
4.3 Mounting the part-turn actuator
4. Place the carrier
socket cap screw
Figure 4-6
5. With the coupling wheel: Place the positioner and the mount on the actuator carefully.
The pin of the coupling wheel
With the stainless steel coupling: Place the positioner and the mount on the actuator
carefully. Place the stainless steel coupling on the stump of the actuator's positioner
shaft.
6. Align the positioner/mount at the center of the actuator.
7. Tighten the positioner/mount unit.
8. Initialize the positioner.
9. After commissioning, drive the positioner to the end position.
42
②
on the stump of the actuator shaft. Tighten the carrier
⑨
and the washer
Carrier
Orientation of mount
⑩
.
①
must fit in the carrier
Orientation of mount, flameproof enclosure
Operating Instructions, 09/2014, A5E00074631-12
②
②
when you do this.
SIPART PS2 with and without HART
using the